Adaptec Serial ATA RAID 2410SA Driver
Buy Microsemi Adaptec Serial ATA RAID SA - Storage controller (RAID) - 4 Channel - SATA Gb/s low profile - Gbit/s - RAID 0, 1, 5, 10, JBOD - PCI. Find many great new & used options and get the best deals for Adaptec Serial ATA RAID sa 4-port at the best online prices at eBay! Free shipping for many. The Adaptec Serial ATA RAID SA is a 4-port native Serial ATA I/O processor-based RAID controller that supports Adaptec's advanced feature set, including.
|Supported systems:||ALL Windows 32x/64x|
|Price:||Free* [*Free Registration Required]|
Adaptec Serial ATA RAID 2410SA Driver
A noticeable share of Serial ATA devices is intended for professional use. It should even force out some other more expensive interfaces from the market of entry-level professional storage devices.
Among other things, a very useful feature is the hot-swap function of storage drives, initially built into the SATA interface. In this article we are going to review its main features. The bundle is simple: The bundle also includes a special 4-wire cable to connect the enclosure to the controller running order indicators on the Adaptec Serial ATA RAID 2410SA panel of the enclosure: The enclosure comes in two colors — beige on the photo and black.
The manufacturer offers three-year warranty for this kit. It's a relatively old controller — it appeared together with the SATA interface.
- Adaptec - Adaptec Serial ATA RAID SA
- Adaptec Serial ATA RAID SA Enclosure Kit
- About this product
Adaptec traditionally uses this processor in its products and has already fine-tuned universal Adaptec RAID code: Perhaps, the main difference of the sole AARSA controller from the same controller in the SA Enclosure Kit is a special 4-pin connector in the latter on the photo on the rightintended for plugging a signal cable from the enclosure, which controls LEDs on its front panel. Each individual bay is equipped with a flap handle Adaptec Serial ATA RAID 2410SA removal and a latch hard drives cannot be locked with a key.
The sleds are numbered from Port 0 to Port 3 that's why you should stick to this order, when you install hard disks into the enclosure.
The enclosure itself has two indicators at the side — fan mode and system overheating. Its rotational speed can be controlled automatically depending on the temperature inside the enclosure there are special jumpers on the board for this purpose.
: Adaptec R SA 4CH SATA RAID Controller Kit: Electronics
Serial ATA ports channels are numbered on the board. There are four SATA connectors with filtered power supply at the back of the enclosure board, so that it's no problem to install and remove hard drives, even when the system is running.
There are two unpackaged LEDs near each of these connectors see the photo of a connector above. Their light is "delivered" to the front panel of the enclosure through plastic light Adaptec Serial ATA RAID 2410SA they are laid on the sledge under a hard drive. And finally, there is a special pin-connector at the back for a 4-wire cable to the AARSA controller.
The main control features like enclosure management, S. Controller's BIOS contains a proprietary utility to monitor and configure operating parameters of the controller and connected drives.
The latest technology Adaptec R. RAID-on-Chip is evidently not supported either.
Especially as the SA Enclosure Kit is a completely tested product. Nevertheless, we still carried out some tests for the controller — four-drive RAID 10 versus a couple of controllers from other manufacturers: All the more interesting it will Adaptec Serial ATA RAID 2410SA to determine which model is the fastest in RAID 10 easy to calculate.
BIOS and driver versions for the Adaptec controller — 7. We used the following testbed configuration to test storage drives: Intel Pentium 4 3. Maxtor 6EL0 Power supply: